Janome AT2000D - Threading Loopers with the Looper Threading Wire or Standard Thread; Using the Looper Threading Wire

26
Threading Loopers with the Looper Threading
Wire or Standard Thread
If the looper threads are made from materials that are
difcult to thread, such as wooly nylon, there are 2
ways to thread the looper threads:
• Use the looper threading wire (looper threader)
• Tie the thread to standard thread, which you then
use to thread.
q
q
w
e
r
t
t
z x
c
v b
n m
,
CAUTION
Turn the power switch OFF before threading the
machine.
Using the looper threading wire
z Pass the thread up to the looper thread guide (before
the looper threader hole).
x Set the looper threader switch lever to the
“THREADING” position.
q Looper threader switch lever
c Turn the handwheel toward you slowly until it clicks.
This locks the handwheel in place.
w Handwheel
v Pass the straight end (not the loop end) through the
looper threader hole until it comes out from the the
hole of the looper tip.
e Loose end of looper threading wire
r Looper threader hole
b Pass approximately 2˝ (5 cm) thread through the loop
of the looper threading wire.
t Thread
n Pull the loose end of the looper threading wire until
the thread comes out from the hole of the looper tip.
m Remove the thread from the looper threading wire.
, Return the looper threader switch lever to the
“SEWING” position.
CAUTION
Do not raise or lower the looper thread lever while
threading.