24
⁄0
⁄4
⁄1
⁄2
⁄3
!5
!5
!8
!6
!7
i
⁄0 Raise the looper threader lever until it clicks into
place.
!5 Looper threader lever
⁄1 Lower the looper threader lever until it knocks into
place.
⁄2 Make sure that the thread comes out from the hole of
the upper looper tip.
!6 Thread end
!7 Hole of lower looper tip
⁄3 Draw 4˝ (10 cm) of the thread under the toe of the foot,
and pull it to the rear between the foot and the upper
knife.
!8 Upper knife
⁄4 Return the lower threader switch lever to the “SEWING”
position.
i Lower threader switch lever
Close the looper cover and lower the presser foot
lifter.
NOTE:
If the thread does not come out from the hole, follow
the procedure from step ⁄0 again.
To Next Page
Loading...
