29
v Pull the thread down along the slit and draw it to the
left through the thread path.
y Slit
u Thread path
b Pull the thread up and along the left side of the thread
take-up lever cover and pass it over the take-up lever
thread guide.
i Thread take-up lever cover
o Thread take-up lever thread guide
v b
n
⁄0
m
v
b
n
m
,
.
y
u
u
i
o
o
i
!0
!1
!2
!3
n Pass the thread through the right slit of the needle
thread guide.
!0 Needle thread guide
m Pass the thread through the needle bar thread guide
from left to right.
!1 Needle bar thread guide
, Thread the right needle from front to back.
!2 Right needle
* Use the needle threader (refer to page 30).
. Pull out approximately 4˝ (10 cm) of thread from the
needle and slide it under the foot so that it runs in
between the foot and the upper knife.
!3 Upper knife
⁄0 Close the looper cover and lower the presser foot
lifter.
* Refer to pages 31 and 32 for details on how to
thread the left needle.
To Next Page
Loading...
