32
v Pull the thread down and along the slit and draw it to
the left through the thread path.
y Slit
u Thread path
b Pull the thread up and along the left side of the thread
take-up lever cover and pass it over the take-up lever
thread guide.
i Thread take-up lever cover
o Thread take-up lever thread guide
v b
n
⁄0
m ,
.
v
b
n
m
i
o
u
u
y
i
!0
!1
!2
!3
o
n Pass the thread through the left slit of the needle
thread guide.
!0 Needle thread guide
m Pass the thread through the needle bar thread guide
from left to right.
!1 Needle bar thread guide
, Thread the left needle from front to back.
!2 Left needle
* Use the needle threader (refer to page 30).
. Pull out approximately 4˝ (10 cm) of thread from the
needle and slide it under the foot so that it runs in
between the foot and the upper knife.
Refer to pages 28 and 29 for details on how to thread
the right needle.
⁄0 Close the looper cover and lower the presser foot
lifter.
To Next Page
Loading...
