52
Replacing the Light Bulb
1 Turn of the power switch and unplug the
machine.
Loosen the face plate set screw, and remove
the face plate.
To remove:
2 Pull out the lamp socket from the holder and
remove the light bulb from the lamp socket.
To replace:
3 Put a new bulb in the lamp socket.
4 Attach the face plate and tighten the set
screw.
1 Face plate
2 Light bulb
3 Holder
Cleaning the Feed Dog
1 Open the looper and side covers.
2 Remove the needles and presser foot.
3 Move the chaining finger setting knob to
“R” position.
4 Remove the needle plate set screw and the
needle plate.
5 Remove the lint around the feed dogs
with the lint brush.
6 Replace the needle plate, presser foot and
needles.
Close the looper and side covers.
1 Needle plate
2 Needle plate set screw
3 Lint brush
1, 2, 3, 4
1
2
1
2
3
5, 6
SECTION 4 MAINTENANCE
3
To Next Page
Loading...
