2.6.5 Robot IP Address Settings
You can set up the robot’s IP address from the PC software JR C-Points II (optional). (This is also
possible with Limited Edition)
Open the JR C-Points II robot IP address settings dialog by clicking [Robot] Æ [IP-Address Settings].
• IP Address (initial settings: 192.168.200.180)
• Subnet Mask (initial settings: 255.255.255. 0)
Enter these values and click the [Setting] button to send the settings to the robot.
Turn the power to the robot OFF and then ON again to apply the new settings.
You can also set up the robot IP address settings from the teaching pendant.
Connect the teaching pendant, and turn the power to the robot ON. Display the screen; [Administration
Mode] Æ [Administration Settings Mode] Æ [Ethernet Settings] and make the following settings:
• IP Address (initial settings: 192.168.200.180)
• Subnet Mask (initial settings: 255.255.255. 0)
Turn the power to robot OFF and then ON again to apply the new settings.
NOTE
After modifying the settings and exiting [Administration Settings Mode], the system is reset and the
settings are enabled.
2.6.6 PC IP Address Settings
Set the IP address if the IP address is not already set on the PC.
Set the IP address with IPv4 as the robot is not compatible with IPv6.
If the IP address is already set, you do not need to set the IP address again.
• The IP address setting method varies depending on the Windows® version you are using. Set the
IP address by referring to the manual supplied with your PC.
• For the IP address, we recommend using a class C private IP address (192.168.0.0 –
192.168.255.255). However, you cannot set 0 and 255 to the right end of the IP address (4
th
octet).
• If you want to set a new IP address to the PC, contact your network administrator.
32
To Next Page
Loading...
