Janome JR3200 series - Program Number Switching Method

Setup
Desktop Robot JR3000
MENU [All Program Common Settings]
[I/O Settings]
[Program Number Reading Format]
[Data] Æ [All Program Common Settings] Æ [Common Data]
8.2.3 Program Number Switching Method
If you want to change program numbers by connecting a digit switch to the I/O terminal, select [Load at
Start].
Selection
Description
LOAD/ACK Handshake
When the Program Number LOAD Signal comes ON, the status of
the I/O Signal Program Number 1 – 512 is loaded (for the Fieldbus,
the status of the program number register is loaded), the Program
Number ACK signal is output, and the program number changes.
Load at Start (I/O-SYS)
When the start instruction is received, the status of the I/O signal
program number 1 –
512 is loaded, and the program number
changes.
Load at Start (Fieldbus)
When the start instruction is received, the status of the program
number register is loaded, and the program number changes.
NOTE: Program Number 1 – 64 signals are loaded under the default [Program Number Switching
Method] settings. If you wish to use the Program Number 128/256/512 signal, you need to
change the signal function in the [I/O-SYS Function Assignment] settings.
MENU [All Program Common Settings]
[I/O Settings]
[Program Number Switching Method]
[Data] Æ [All Program Common Settings] Æ [Common Data]
Program Number
LOAD Signal
Program
Number
1
– 512
Program N
umber
ACK Signal
Acquire
ACK
LOAD
Acquire
Program Number
1 – 512
Start Signal
LOAD/ACK Handshake
Load at Start
TP
PC
TP
PC
46