Janome JR3200 series - 9 Converting Jr2000;Jr2000 N Data to Jr3000 Data

Setup
Desktop Robot JR3000
9. CONVERTING JR2000/JR2000N DATA TO
JR3000 DATA
To use JR2000/JR2000N series teaching data as JR3000 series C&T data, it is necessary to convert
the data. The following three steps are needed to convert data:
1. Use JR Points (JR2000 optional) and/or JR C-Points (JR2000N optional) to send the data to the
PC.
2. Open the data received from step 1 using JR C-Points II*.
3. Send the data from the PC to the JR3000 using JR C-Points II*.
*In place of JR C-Points II (optional), JR C-Points II Limited Edition (included in the Operation Manual
CD) can also be used to convert data.
NOTE
It is possible to connect one PC to both a JR2000/JR2000N Series robot and a JR3000 Series
robot at the same time. You can also connect a PC to the JR2000/JR2000N Series robot, receive
the data, disconnect the JR2000/JR2000N robot, and then connect the JR3000 Series robot.
(To convert data using one PC, JR-Points or JR C-Points and JR C-Points II must be installed on
the PC.)
Teachi ng Da ta
Connect
Connect
JR2000/JR2000N
Example: JR2203N
PC(JR-Points/
JR C-Points)
PC(JR C-Points II)
JR3000 Series
Example: JR3203N-AC
Caution
Make sure to turn OFF the robot before removing or connecting
cables. Failure to do so may cause unit malfunction or data loss.
48