Precautions when converting from JR-Points to JR C-Points II
• The sysFlag numbers for point jobs, execute conditions, PLC programs etc., do not change when
they are converted over from JR-Points, however, contents of some items have changed with
JR C-Points II. Please confirm after converting over to JR C-Points II.
Precautions when converting from JR C-Points to JR C-Points II
• Point job numbers 101 – 200 for JR C-Points are, depending on Protect Mode, converted as
follows:
Point job numbers of items in [No Limit] and [Public] Protect Mode do not change. For this reason,
these items can be run as they are.
Items in [Protected] and [Private] Protect Mode are converted with +400 added to their point job
number to protect the defined content. For this reason, these items cannot be run as they are.
Please amend this data.
• With JR C-Points II, TPIF (Port 4) has been removed from the COM ports. For this reason, items
which are specified to TPIF (Port 4) in JR C-Points are converted to COM 1. However, point jobs
are not converted, so please amend this data.
• The various display order of T.M.C settings are not converted.
50
To Next Page
Loading...
