Janome MC 11000 - Care and Maintenance; Cleaning the Hook Race and Feed Dog

94
CARE AND MAINTENANCE
This machine equipped with LED sewing light, which
will not burn out and does not need to be replaced.
Cleaning the Hook Race and Feed Dog
Press the up/down needle button to raise the needle,
then unplug the sewing machine.
Remove the needle and presser foot.
NOTE:
Do not dismantle the machine other than what is
explained on this page.
1. Remove the setscrews with the screwdriver key
supplied with the machine. Remove the needle plate.
1 Setscrews
2 Needle plate
2. Take out the bobbin and bobbin holder.
3 Bobbin holder
3. Clean the bobbin holder with a lint brush.
4 Lint brush
4. Clean the feed dog and auto thread cutter device
with the lint brush.
5 Feed dog
6 Auto thread cutter device
5. Clean the hook race with a soft dry cloth.
7 Soft dry cloth
Assembling the hook race
6. Insert the bobbin holder so that the knob fits next to
the stopper in the hook race.
Insert the bobbin.
8 Knob
9 Stopper
7. Reattach the needle plate, aligning the guide holes
on the needle plate with the needle plate guide pins
and tighten the screw.
10 Guide holes
11 Needle plate guide pins
NOTE:
After cleaning the machine, make sure the needle and
presser foot are attached.
1
2
3
4
5
6
7
8
9
10
11
1
2
3
4
5
6
7