Janome Memory Craft 400E - CUSTOMIZING EMBROIDERY MODE SETTINGS; Embroidery Mode Configuration

51
CUSTOMIZING EMBROIDERY MODE
SETTINGS
Embroidery Mode Settings
Press the embroidery setting mode tab (refer to page 48).
q
Auto thread tension
The auto thread tension level can be adjusted with the
“+” or “–” key. Increase the value when using the same
threads on the bobbin and needle.
w
Low bobbin thread warning
The low bobbin thread warning level can be adjusted with
the “+” or “–” key. To turn this option off, press the “–” key
until “OFF” shows in the window.
Press the next page key to go to the next menu.
e
Maximum embroidery speed
The maximum embroidery sewing speed can be set from
400 to 860 spm in 100 spm intervals by pressing the “+”
or “–” key.
r
One stitch stop
When this function is turned on, the machine sews one
stitch and stops automatically so that you can bring the
bobbin thread up before sewing.
t
Consecutive color grouping
If an imported design les of a pattern combination
contain consecutive sections in the same color, these
sections are automatically grouped together as one
section when opening the le or going to the ready to sew
window. This function is invalid when combining the built-
in designs and externally sourced designs.
Turn this option off if you do not wish to group the
sections together.
q
w
e
r
t
y
Hoop conrmation
The hoop conrmation message will appear every time
before opening the ready to sew window. However you
can turn this option off by selecting off.
y