Janome mystyle 16 - Wind the Bobbin

SECTION 2.
PREPARE YOUR
MACHINE FOR
SEWING
Prepare the Bobbin
* To Remove the
Bobbin from the Machine a Wind the Bobbin
1. Gently push down on the bobbin cover plate and slide
it
towards
you.
Bobbm
wind,,q
s:vrdle
*
2. Set aside.
3. Lift out the
bobbin, as shown. 1. Put your spool of thread onto spool pin, with the thread winding in
the direction
shown.
2. Pull the clutch away from the machine to stop the needle from moving while you
winding the bobbin.
3. Draw thread from spool through bobbin winder tension disc as shown.
4. Place the threaded
bobbin on the bobbin winding spindle so that the thread comes
out on top.
5. Push the bobbin winder spindle to the right until it clicks.
6. Holding onto
end of thread, depress the foot
control.
7. When the bobbin is slightly filled, stop the machine and clip the thread
coming from
the bobbin.
8.
Slowly
start
the machine
again
and
wind
the thread
until
the bobbin
stops.
9. Push the bobbin winder spindle
to the left and clip the thread.
10. Remove the bobbin.
11.
Push
in
the
clutch
for
normal
sewing
operation.
13