Janome mystyle 16 - Setting Spool Pins; Adjust the Presser Foot Lever; Thread Cutter

SECTION 2. PREPARE YOUR
MACHINE FOR SEWING
Set Up the Machine
(Continued)
* Setting Spool Pins
e Adjust the Presser Foot Lever
a Thread Cutter
Spool
pin felt
Spool pin
~Thraad
No.mat u•p
position
High
~position
.p
Normal
op
Highposition
P-esser loot
lever
The spool pins are used for
holding the
You don't need a pair of
scissors to cut the
spools of thread in order to feed thread
to
thread after you finish sewing.
Just use the
the machine,
handy thread cutter.
To use,
pull up the spool pins. Place the
The Presser Foot Lever
raises and lowers your
The threads are cut the proper length
for
spool felt on the pins. Push down
for presser foot starting the next seam.
storage.
You can raise it about 0.6
cm higher than the
normal
up position for easy removal of the presser
foot or to help you place heavy
fabrics under the
presser foot.
6