[1]
[2]
[3]
[4]
1
2
3
5
4
•
Inserting the bobbin
[1]
Remove the hook cover and place the bobbin in
the bobbin holder with the thread running counter-
clockwise.
[2]Guide the thread into the notch A on the front side
of the bobbin holder. Draw the thread to the left
sliding it between the tension spring blades.
1. Notch A
[3]Continue to draw the thread lightly until it slips into
notch B.
2 Notch B
[4]Pull out about 10 cm (4˝) of thread and attach the
hook cover.
3. Bobbin thread
4. Hook cover plate
5. Threading diagram
11
To Next Page
Loading...
