Janome OC 6125 - Cleaning Hook Race and Feed Dog; Replacing Bobbin Holder and Needle Plate

[1]
[2]
[3]
[4]
[5]
[1]
[2]
[3]
2
1
3
4
5
6
7
8
2
3
Cleaning Hook Race and Feed Dog
WARNING: Raise the presser foot and needle, and
then unplug the machine.
DO NOT dismantle the machine other
than as explained in this section.
[1] Remove the needle and presser foot.
Remove the two setscrews and unhook the hook
to remove the needle plate.
1. Needle plate
2. Setscrew
3. Hook
[2]Take out the bobbin and bobbin holder.
4. Bobbin holder
[3] Clean the bobbin holder with the lint brush and
soft dry cloth.
[4] Brush out dust and lint from the feed dog and
clean the hook race with the lint brush.
5. Feed dog
[5]Wipe inside of the hook race with a dry cloth.
6. Hook race
NOTE: You may use vacuum cleaner.
Replacing Bobbin Holder and Needle Plate
[1]Insert the bobbin holder.
[2]Fit the knob next to the stopper in the hook race.
7. Stopper
8. Knob
[3]Insert the bobbin and attach the needle plate
aligning the hook.
NOTE: After cleaning the machine, make sure to
attach the needle and presser foot.
39