Janome OC 6125 - Stitch Width Adjustment; Variable Needle Position; Stitch Length Adjustment

01234
01234
2
1
3
3
2
1
Stitch Width Lever
Slide the stitch width lever to set the setting mark at
the desired stitch width.
*
The higher the number, the wider the stitch width.
1. Stitch width Lever
2. Setting mark
NOTE: Raise the needle above the fabric when sliding
the stitch width lever.
Variable needle drop position
When one of the straight stitches (patterns #2, 23 and
24) is selected, you can move the needle between
center and left needle positions.
3. Hole on the needle plate
Stitch Length Lever
Slide the stitch length lever to set the setting mark at
the desired stitch length.
The higher the number, the longer the stitch length.
NOTES: “ ” mark indicates the adjustable
allowance for buttonhole stitch density.
Raise the presser foot when sliding the
stitch length lever.
1. Stitch length lever
2. Setting mark
16