20
b Draw the thread down and pass it through the right
hole in the guide plate.
q Right hole in the guide plate
n Pass the thread through the eye of the right check
spring.
w Eye of the check spring
m Pull the thread up and pass it through the second
hole from the right.
e Second hole from the right
, Continue to pull the thread up to the right take-up
lever. Pass the thread through the eye of the take-
up lever.
r Take-up lever
. Draw the thread down and pass it through the third
hole from the right in the guide plate.
t Third hole from the right
⁄0 Continue to draw the thread down to the lower
guide plate and pass the thread through the right
hole.
y Right hole in the lower guide plate
⁄1 Hold the thread with both hand and slip the thread
behind in the right needle bar thread guide.
u Needle bar thread guide
⁄2 Thread the needle with the handy needle threader
(refer to the next page).
⁄3 Pass the thread through the hole in the presser
foot.
Draw the thread up and pinch the thread tail with
the holder spring.
i Hole in the presser foot
o Holder spring
⁄4 Pull up the tension release lever to close the
tension disks.
!0 Tension release lever
q
w
e
r
t
y
u
i
o
!0
b
n
m
,
.
⁄0
⁄1
⁄22
⁄3
⁄4
To Next Page
Loading...
