Jasic TIG 315P Multi Wave - Spot Welding Parameters; Hybrid (Mix) Mode Settings

A WILKINSON STAR LIMITED PRODUCT 01-19 ISSUE 1
Spot mode
When welding in the spot mode use the adjuster to
navigate the On LED (1). Press the adjuster (the LED
will ash) and adjust to the desired spot me. Press
the adjuster to save the parameter (the LED will
stop ashing).
Use the adjuster to navigate the O LED (2). Press
the adjuster (the LED will ash) and adjust to the
desired o me. Press the adjuster to save the
parameter (the LED will stop ashing).
Example:
The On me is set at 1 second and the O me at 5
seconds.
When the torch switch is operated the arc will be
on for 1 second and then o for 5 seconds and will
repeat unl the torch switch is released.
Hybrid (Mix) mode:
When operang in hybrid mode it is necessary to
set the hybrid frequency and me.
When in Mix mode TIG use the adjuster to navigate
the Hz LED (1). Press the adjuster (the LED will ash)
and adjust to the desired frequency. Press the
adjuster to save the parameter (the LED will stop
ashing).
Use the adjuster to navigate the DC duty % LED (2).
Press the adjuster (the LED will ash) and adjust to
the desired duty percentage. Press the adjuster to
save the parameter (the LED will stop ashing).