Jasic TIG200 - Technical Parameters

Page 13
service life of the fan.
◆ TIG arc starting mode: Supports HF and lift arc starting with a high success rate.
◆ Multiple TIG operation modes: 2T, 4T, repeat, and spot welding.
◆ Parameters are automatically saved before shutdown, and the settings are restored after
starting again.
◆ Compatible with various remote control methods: The plus version supports
analog/digital remote control torch, wired/wireless foot pedal controller, and wireless
handheld remote controller in TIG mode, and supports wired/wireless handheld remote
controller in MMA mode; and the standard version supports analog remote control torch,
wired foot pedal controller and wired handheld remote controller. Of course, wireless remote
control requires a separate special receiving module and remote controller.
◆ Multiple user modes are supported. Users can restore factory settings, view barcodes on
the machine, enable the standby function, set the response time, and enable input
overvoltage and undervoltage protection.
4. Technical parameters
Item
Unit
Parameters
Model
/
TIG200P PFC
TIG200 PFC
TIG200P
TIG200
Input voltage
VAC
AC95~265V
AC95~265V
AC230V±15%
AC230V±15%
Input frequency
Hz
50/60
50/60
50/60
50/60
Rated input current
(AC230V)
A
19.5@TIG
25.6@MMA
19.5@TIG
25.6@MMA
27@TIG
29@MMA
27@TIG
29@MMA
Rated input current
(AC115V)
A
29.7@TIG
31.6@MMA
29.7@TIG
31.6@MMA
/
/
Rated input power
(AC230V)
kVA
4.5@TIG
5.9@MMA
4.5@TIG
5.9@MMA
6.2@TIG
6.7@MMA
6.2@TIG
6.7@MMA
Rated input power
(AC115V)
kVA
3.4@TIG
3.7@MMA
3.4@TIG
3.7@MMA
/
/
No-load voltage
V
68
68
62
62
VRD voltage
V
10.5
10.5
10.5
10.5
TIG
Welding current
(AC230V)
A
5~200
5~200
5~200
5~200
Welding current
(AC115V)
A
5~160
5~160
/
/
Welding voltage
(AC230V)
V
10.2～18
10.2～18
10.2～18
10.2～18
Welding voltage
(AC115V)
V
10.2～16.4
10.2～16.4
/
/
Pre-flow time
s
0~3
0~3
0~3
0~3