Page 37
7.2. DC TIG operation
7.2.1 Turn on the power switch
(Same as 7.1.1)
7.2.2 Select DC TIG welding mode
Figure 7-4 DC TIG mode
7.2.3 Select the arc starting mode
The arc starting mode includes lift arc starting and HF arc starting, which can be selected
according to the actual conditions.
7.2.4 Select welding method
The welding methods are spot welding, 2T welding, 4T welding and repeat welding, and can
be selected according to the actual conditions. Refer to Table 7-2 for details.
To Next Page
Loading...
