Page 43
7.3.6 DC pulse TIG welding
Open the valve on the gas cylinder, adjust the argon flow, and realize TIG welding by lift arc
starting or HF arc starting.
During welding:
1) The TIG parameter indicator changes with the welding state
2) If the parameter indicator is in initial current, peak current, base current or finish current,
directly press the encoder to adjust the value, and the parameter indicator will flash
3) If the parameter indicator is in pre-flow time, up-slope time or down-slope time, the value
cannot be adjusted, and operations on the encoder will not be effective
After welding, release the torch trigger to extinguish the arc.
7.3.7 Turn off the power supply after welding
(Same as 7.1.4)
To Next Page
Loading...
