Jayco 2016 Melbourne - To Replace Filter Cartridge; Filter Housing

99
plumbing SyStem
To Replace Filter Cartridge
1. Turn off water supply using two valves located on the
water lines on each side of the canister.
2. Place drip pan below lter housing to catch any spillage.
3. Press the red button on top of the lter housing to release
pressure.
4. Using a spanner wrench, rotate the lter housing. Unscrew
the housing completely and remove the lter (dispose of
the old lter properly.
5. Clean the inside of the lter housing with mild detergent.
Thoroughly rinse and wipe clean.
6. Remove the o-ring from the groove in the housing and
wipe clean. Recoat with petroleum jelly.
7. Replace the o-ring in the groove, making sure it is
properly seated.
8. Install the new lter cartridge.
9. Replace the canister housing (hand tighten is normally sufcient).
10. Turn on the water supply and check for leaks.
Each new recreation vehcicle is winterized with RV antifreeze before it is shipped to the
dealer. To use the water purication system: full system canister water lines need to be
ushed of antifreeze and then the lter installed in the canister before use.
Refer to the manufacturer’s owner’s manual and the label on the water lter cartridge for
further information.
Filter housing
 Do not allow the lter housing to freeze.
 Remove the cartridge before using anti-freeze to winterize the system or
chlorine solution to sanitize the system.
 Flush housing thoroughly before it is put back into service after
winterizing or sanitizing.
 For best results replace cartridge every 6-12 months.
 Do not use carbon cartridges where water is microbiologically unsafe or
of unknown quality.
 Maximum operating pressure is 125 psi (8.75 bar).
 Maximum water temperature is 125° F (52° C).

NOTE:There is no bypass feature on a canister style water lter.
The water lter must be removed before sanitizing or winterizing the
RV.
Table of Contents
Maintenance Record