Jayco 2016 Melbourne - Privacy Drape Installation; Bed Storage; ABS Plastics

139
interiOr
To care for the vinyl oor covering, use a damp mop with water and a mild cleaner on
the entire oor. DO NOT SOAK THE FLOORING. Use care to avoid wetting the carpet
edges. To avoid problems of “yellowing” linoleum, the ooring manufacturer recommends
avoiding cleaners that contain oil based solvents (i.e. cleaners containing lemon oil,
Murphy’s Oil Soap, etc.).
privAcy drApe instAllAtion
Starting at the driver’s side of the cab, attach the black plastic hook to the loop attached to
the wall behind the driver’s seat. Make sure that the side of the drape with Velcro® is facing
the motorhome windshield.
1. Pull the drape toward the front of the motor home and behind the driver’s side sun visor.
Open the sun visor against the windshield to hold the drape in place.
2. Proceed across the windshield to the passenger side, again placing the drape behind the
sun visor and opening the sun visor to hold the drape in place.
3. Attach the black plastic hook at the passenger’s side of the cab to the loop attached to
the wall behind the passenger’s seat.
4. Attach the Velcro® at the top edge of the drape above the driver’s and passenger’s
doors to the corresponding Velcro on the roof of the motorhome cab.
5. The Velcro® at the bottom corners of the privacy drape under the black plastic
hooks should also be attached to the Velcro on the walls of the motor home in the
corresponding locations.
bed storAGe
Additional storage has been provided under the bed. It is equipped with gas struts to assist
with easy access. To access the storage area, grasp the end ledge at the foot of the bed
and lift carefully. To close, carefully push down on the bed slowly easing it to the closed
position.
The bedroom electric slide room system may be located under the bed. Use care not to
obstruct the slide room system when using the under bed storage area.
Before lifting, be sure there is nothing on the bed that will restrict its movement
or add extra weight. Use caution when opening or closing the bed to keep
hands and ngers at the end ledge provided (not on the side or further back
than necessary) to avoid pinch points.

Abs plAstics
Dust and wipe clean with soft, damp cloth or chamois, wiping gently. Do not use gritty or
abrasive particle soaps or scouring compound to clean ABS plastic. Avoid using “citrus” or
biodegradable cleaners which contain “D-Limonene” as they may damage plastic materials.
Table of Contents
Maintenance Record