Jayco 2016 Melbourne - Cold Weather Usage; Condensation

28
Occupant Safety
condensAtion
Condensation is a natural phenomenon. The amount of condensation will vary with climate
conditions, particularly the relative humidity. Condensation occurs because there is water
vapor present in the air, which each of us adds to by breathing, bathing or cooking. The
water vapor usually collects on the coolest surfaces. When the temperature reaches the “dew
point” the water vapor in the air condenses and changes to a liquid form.
Proper ventilation and, if needed, the use of a dehumidier (customer supplied) will assist in
controlling the condensation. Many RV and marine dealers carry small dehumidiers sized
for recreation vehicle use. Other suggestions are:
 Crack open windows and roof vents to allow warm moist air to escape.
 When taking a shower open the bath roof vent (if so equipped) approximately ½”
allowing the moisture to escape.
 Use the range hood fan (if so equipped) when cooking or washing dishes.
 Avoid hanging wet towels (or clothes) inside the recreation vehicle to dry.
 If condensation is found in cabinets or closets, open those doors slightly to equalize the
temperature and provide ventilation.
Condensation may cause dampness, mildew, mold, staining and, if allowed to
continue, it may result in damage to the recreation vehicle (damage caused by
condensation is not warrantable). It can also lead to mold or mildew issues,
which could be a health hazard.

cold WeAther usAGe
When used in freezing or below freezing temperatures, the following precautions need to
be taken:
 Proper care should be taken with the fresh water and drainage systems to avoid freeze-
ups.
 Propane gas (if so equipped) and sufcient power is needed for protection from possible
freeze-ups on the propane gas regulator. Keep in mind that more frequent furnace
operation will substantially increase battery draw and propane gas use.
 During cool weather usage, ventilation or addition of a dehumidier may be required
to reduce condensation.
 Check outside extrusions on compartment doors, locks, slide outs, windows, vents, etc.,
for frozen moisture before operating to avoid damage to parts.