Jayco 2016 Melbourne - Servicing or Filling; LP Gas Container Overfill; ASME Tank

87
fuel & prOpane SyStem
Servicing or lling
Because the container is not removable, the motor home will need to be driven to a qualied
propane facility for servicing or lling.
Only the authorized gas service technician(s) should be near the motor home while the
propane tank is being lled. The new propane container must be carefully purged for proper
appliance performance and operation. The propane tank must NEVER BE OVERFILLED.
Replace all protective covers and caps on the propane system and/or container after lling.
Make sure the valve is closed and the compartment door is securely latched.
LP gas container overll
Never allow your propane tank to be lled above the maximum safe level as indicated by
the xed liquid level gauge.
Do not allow the visible gauge to be used for lling. Overlling the propane container above
the liquid capacity indicated on the container, could allow liquid propane to enter the system
that is designed for vapor only creating a hazardous condition.
The following warming label has been placed by the propane container.Propane system.
ASME Tank
1: Propane fill valve; 2: Propane gauge
Always shut OFF the engine while refueling. Do not smoke and do not operate
other ignition sources while refueling.

When the propane container is disconnected from the main supply hose and
the P.O.L. connection, install the P.O.L. plastic cap that is attached to the
container

Table of Contents
Maintenance Record