Jayco 2016 Melbourne - Interior Wall Panel; Flooring; Carpet; Vinyl Flooring

138
interiOr
Difcult stains can be removed from the matte nish with a green Scotch Brite® pad and a
mild abrasive cleaner.
Disinfect the surface periodically with diluted household bleach (one part water to one part
bleach). For cuts and scratches, sand the matte nish lightly with (220) ne grit sandpaper
until the cut or scratch is gone. Restore nish with a green Scotch Brite

pad and mild
abrasive cleaner.
Helpful hints
 Use a cutting board to prevent unnecessary damage to the countertops. Do not cut
directly on the solid surface countertop.
 Use potholders or trivets before placing hot pots and pans on the countertop. Heat will
damage the countertop.
 Run cold water when pouring hot/boiling water into the sink.
Solid surface sink maintenance
Occasionally, clean the solid surface sink by lling one-quarter full with a 50/50 water/
bleach solution. Let soak for 15 minutes, and then wash sides and bottom of sink as solution
drains.
Do not use abrasive cleaners as they may cause the vinyl to scratch and
become dull. Do not use cleaners that contain bleach

interior WAll pAnel
Please contact your dealership service department for assistance in repairing décor paneling.
If deep scratches occur on the wall panel, putty sticks can be used to cover scratches on
wood surfaces. These can be obtained from local hardwood stores and lumberyards.
To clean, use a mild solution of soap and lukewarm water with a soft sponge or cloth. Wipe
dry with a soft, clean cloth.
floorinG
Always test a cleaning agent in an inconspicuous area for colorfastness.
Carpet
Vacuum your carpet regularly. It is important to remove loose soil and debris while it is on
the surface. Heavily traveled areas (i.e., walkways, areas in front of the furniture) may be
protected with small throw rugs to prolong the life of the carpet.
Prompt attention to spots and spills is essential. Remove as much of the spill as possible.
Absorb wet spills as quickly as possible by blotting repeatedly with white paper or cloth
towels.
Refer to the manufacturer’s guide included in your Warranty Packet for detailed cleaning
information, or contact a cleaning professional.
Vinyl ooring
Periodically vacuum or sweep to remove dirt and gritty particles. Although most common
spills will not permanently stain the vinyl oors, they are usually easier to remove if wiped
up before they set. Simply blot with a paper towel and wipe clean with a damp cloth. Do not
use dish detergents or vinegar and water because they will dull your oor.