Need help?Do you have a question about the JBL CSA-2120 and is the answer not in the manual?
General| Output Power (two channels at 1 kHz power, THD+N<0.5%): | 4 Ohms 120 W 8 Ohms 120 W |
|---|---|
| Frequency Response (1 watt into 4 or 8 Ohms): | +1/-1 dB |
| Load Impedance: | Rated for 4 or 8 Ohms |
| Sensitivity (8 Ohms load): | 1.4 Vrms |
| Signal to Noise Ratio (below rated 8-Ohm power at 1 kHz, A weighted): | >100 dB |
| Crosstalk (Rated into 8 Ohms): | 70 dB below rated from 20 Hz to 1 kHz; 50 dB below rated at 20 kHz |
| Input Impedance (nominal): | Balanced: 20 k Ohms Unbalanced: 10 k Ohms |
| Maximum Input Signal: | +20 dBu typical |
| AC Line Voltage and Frequency Confgi urations Available: | 100-240 V, 50/60 Hz |
| Auto-Standby: | Go into auto-standby: 1 hour Recovery time: < 1 ms Recovery threshold: -60dBu |
| Operating Temperature: | 0° C to 40° C at 95% relative humidity (non-condensing) |
Weight and Dimensions| Dimensions (W x H x D) : | 8.2” x 1.7 x 7” (209 mm x 44 mm x 178 mm) |
|---|---|
| Net Weight: | 1 kg (2.1 lbs) |
| Shipping Weight: | 1.5 kg (3.4 lbs) |
Essential precautions for connecting power cords and proper wiring procedures.
General safety advice covering environment, maintenance, and usage conditions.
Specific safety warning regarding the use of UK mains plugs and fuse replacement.
Guidelines and options for installing the amplifier in cabinets, on walls, or on surfaces.
Important precautions for safe and optimal operation of the amplifier.
To Next Page
