Attachments
Working with Attachments
91 9821/6100-4 91
4. Connect the male coupling into the female coupling.
5. Where applicable, rotate the sleeve half a turn and make sure that the locking ball does not align with
the slot.
Figure 77.
C Ball D Slot
E Sleeve
Disconnecting Quick Release Couplings
1. Remove any residual hydraulic pressure trapped in the service line hose.
2. Where applicable, align the slot with ball.
3. Pull back the sleeve to release the coupling.
Impact Protection
CAUTION When using an attachment for example a hydraulic breaker, where the risk of flying debris is
present, a protective layer or screen guard must be attached to the front of the canopy (or close the cab
front window(s)) to protect the operator from flying debris which could cause injury.
The safety label warns the operator against the risk of flying debris when they use an attachment. The
attachment must not be used if a protective layer or screen guard has not been installed on the machine.
Make sure that the attachment, for example a hydraulic breaker is positioned in front of the cab before it is
operated. Do not slew the boom to the side during operation of the attachment.
Consult your JCB dealer for further information.
Figure 78.
A Safety label B Hydraulic breaker
To Next Page
Loading...
Need help?
General
