Operation
Starting the Engine
43 9821/6100-4 43
Figure 30.
A LED
To Arm the Immobiliser
1. Stop the engine. Remove the ignition key.
2. The immobiliser arms automatically after two minutes. The green LED flashes for 60 seconds, then goes off.
3. If you restart the engine within two minutes, the system disarms automatically.
To Add a New or Additional PIN Code
Before you try to add a new or additional PIN code, make sure that the machine is ready to start and that you
have your six digit master code and your new four digit PIN code available.
If you are unsure of the master code or your new PIN code, then do not start this procedure.
The keypad immobiliser can be programmed to accept up to 14 different four digit PIN codes, any of which
will let the machine be started.
1. Put the ignition key in the ignition switch. Turn the ignition key to position 1
2. Enter your six digit master code using the keypad. Push the 'ENT' button.
3. The LED will flash three times to indicate the acceptance of the master code.
4. Within 59 seconds of the three flashes, push the 'MD' button.
5. Enter your new four digit PIN code using the keypad. Push the 'ENT' button. The LED will flash four times
to indicate that the new PIN code has been successfully entered.
6. Turn the ignition key to the off position, then a minimum of five seconds later, turn the ignition key to position
1. The new PIN code is now entered and recorded.
7. If another PIN code is to be entered, turn the ignition key to the off position, then return to step 1.
To Delete all of the PIN Codes
Deleting all the PIN codes does not allow the immobiliser to be bypassed. A four digit PIN code must be entered
before the machine can be started.
If you are unsure of the master PIN code or your new PIN code, then do not start this procedure.
1. Put the ignition key in the ignition switch. Turn the ignition key to position 1.
2. Enter your six digit master PIN code using the keypad. Push the 'ENT' button. The LED will flash three
times to indicate the acceptance of the code.
3. Push the buttons in the following sequence, 'MD', 'F1', 'ENT'. The LED will flash five times to indicate the
acceptance of the delete command.
To Next Page
Loading...
Need help?
General
