WARNING: The vibration
emission value during actual
use of the power tool can differ from
the declared value depending on
the ways in which the tool is used.
The following examples (by no means
exhaustive) give some indication as to
why the vibration values may vary from
the declared gure:
1) How the tool is used and the
material being cut.
2) That the tool being used is in good
condition and well maintained.
3) That any accessory used is
designed for the tool, and that it is
sharp and in good condition.
4) The tightness of the operators grip
on the handles, and if any
anti-vibration accessories are used.
That the tool is being used as
intended by its design, and in
accordance with these instructions.
This tool may cause hand-arm
vibration syndrome if its use is not
adequately managed.
WARNING: To be accurate,
an estimation of exposure
level in the actual conditions of use
should also take account of all parts
of the operating cycle, such as the
times when the tool is switched off
and when it is running idle but not
actually doing the job. This may
signicantly reduce the exposure
level over the total working period.
Helping to minimise your vibration
exposure risk.
Aways use sharp chisels, drills and
blades.
Maintain this tool in accordance with
these instructions and keep it well
lubricated (where appropriate).
If the tool is to be used regularly then
invest in anti-vibration accessories.
Avoid using tools in temperatures of
10
0
C or less.
Plan your work schedule to spread
any high vibration tool use across a
number of days.
To Next Page
Loading...
Need help?
General
