DO NOT OVER-REACH
Keep good footing and balance.
Stand to one side so that your face
and body are out of line of a possible
kickback.
WARNING: Freehand cutting
is a major cause of accidents
and should not be attempted.
1) Ensure that the workpiece is
always rmly resting against the
fence, and where practical is clamped
with the Hold Down Clamp to the
table.
2) The saw table should be clean and
free from any sawdust etc. before the
workpiece is clamped into position.
3) Ensure that the ‘cut-off’ material
is free to move sideways away from
the blade when the cut is completed.
Ensure that the ‘cut-off’ piece cannot
become ‘jammed’ in any other part of
the machine.
4) Do not use this saw to cut small
pieces. If the workpiece being cut
would cause your hand or ngers to
be within 150mm of the sawblade,
the workpiece is too small.
To Next Page
Loading...
Need help?
General
