Fence Adjustment
The fence must be aligned at 90
0
(square) to a correctly installed blade
The rotary table must be set at ‘0
0
’
mitre angle.
The Fence is fastened to the table
with four (4) socket head hex screws
that are positioned two (2) at either
side in elongated slots.(See )
1. Place a set square on the table
with one short edge against the
Fence and the other short edge
against the Blade.
2. If adjustment is necessary, loosen
the four (4) Fence adjustment screws
using an Allen Key.
3. Re-position the Fence in its
elongated slots until alignment is
achieved.
4. Securely tighten the socket head
screws.
Mitre Angle Pointer Adjustment
NOTE: There are dual mitre angle
scales cast into the front of the
machines base. A small pointer
indicates the angle selected.
Set the rotary table to 0
0
Mitre
ensuring that the 0
0
Positive Stop
is engaged. Check that the Mitre
pointer is in exact alignment with the
0
0
index mark.
36
To Next Page
Loading...
