8 - 41
Assembly (cont’d)
4 Remove the bearing pre-load adjusting jig from spindle
2.
Proceed to step 14 of the assembly procedure.
Axle Clearance of Taper Bearings 22
1 To ensure that the crankshaft/reduction gear assembly is
fully inserted in spindle 2, use Special Tool IV (see
Service Tools, Section 1) to tap the outer shell of bearing
22.
2 Fit the thinnest of the twelve available thicknesses of
snap ring 20 into the groove of holding flange 3.
Section F Transmission
9803/6020
Section F
8 - 41
Issue 1
Track Gearbox
To Next Page
Loading...
