In the Trac-loky differential, part of the ring gear
torque is transmitted through clutch packs which
contain multiple discs. The clutches will have radial
grooves on the plates, and concentric grooves on the
discs or bonded fiber material that is smooth in
appearance.
OPERATION
In operation, the Trac-loky clutches are engaged
by two concurrent forces. The first being the preload
force exerted through Belleville spring washers
within the clutch packs. The second is the separating
forces generated by the side gears as torque is
applied through the ring gear (Fig. 4).
The Trac-loky design provides the differential
action needed for turning corners and for driving
straight ahead during periods of unequal traction.
When one wheel looses traction, the clutch packs
transfer additional torque to the wheel having the
most traction. Trac-loky differentials resist wheel
spin on bumpy roads and provide more pulling power
when one wheel looses traction. Pulling power is pro-
vided continuously until both wheels loose traction. If
both wheels slip due to unequal traction, Trac-loky
operation is normal. In extreme cases of differences
of traction, the wheel with the least traction may
spin.
DIAGNOSIS AND TESTING
GENERAL INFORMATION
Axle bearing problem conditions are usually caused
by:
• Insufficient or incorrect lubricant.
• Foreign matter/water contamination.
• Incorrect bearing preload torque adjustment.
• Incorrect backlash.
Axle gear problem conditions are usually the result
of:
• Insufficient lubrication.
• Incorrect or contaminated lubricant.
• Overloading (excessive engine torque) or exceed-
ing vehicle weight capacity.
• Incorrect clearance or backlash adjustment.
Axle component breakage is most often the result
of:
• Severe overloading.
• Insufficient lubricant.
• Incorrect lubricant.
• Improperly tightened components.
• Differential housing bores not square to each
other.
Fig. 3 Differential Operation—On Turns
1 – PINION GEARS ROTATE ON PINION SHAFT
Fig. 4 Trac-lok
Y
Limited Slip Differential Operation
1 – CASE
2 – RING GEAR
3 – DRIVE PINION
4 – PINION GEAR
5 – MATE SHAFT
6 – CLUTCH PACK
7 – SIDE GEAR
8 – CLUTCH PACK
XJ 194 RBI AXLE 3 - 67
DESCRIPTION AND OPERATION (Continued)
To Next Page
Loading...
