Jeep Cherokee 2000 - Trac-Lok Differential

TRAC-LOKY DIFFERENTIAL
The Trac–loky differential components are illus-
trated in (Fig. 51). Refer to this illustration during
repair service.
DISASSEMBLY
(1) Clamp Side Gear Holding Tool 6965 in a vise.
(2) Position the differential case on Side Gear
Holding Tool 6965 (Fig. 52).
(3) Remove ring gear, if necessary. Ring gear
removal is necessary only if the ring gear is to be
replaced. The Trac-loky differential can be serviced
with the ring gear installed.
(4) Remove the pinion gear mate shaft lock screw
(Fig. 53).
(5) Remove the pinion gear mate shaft. If neces-
sary, use a drift and hammer (Fig. 54).
(6) Install and lubricate Step Plate C-6960-3 (Fig.
55).
Fig. 51 Trac–lok Y Differential Components
1 – THRUST WASHER
2 – PINION
3 – SHAFT LOCK SCREW
4 – PINION MATE SHAFT
5 – SIDE GEAR
6 – RETAINER
7 – DISC
8 – CLUTCH PACK
9 – DIFFERENTIAL CASE
10 – RETAINER
Fig. 52 Differential Case Holding Tool
1 – SPECIAL TOOL 6965
2 – VISE
3 – DIFFERENTIAL
XJ 194 RBI AXLE 3 - 87
DISASSEMBLY AND ASSEMBLY (Continued)