(2) Ensure cup is correctly seated.
(3) Apply Mopart Door Ease, or equivalent, stick
lubricant to outside surface of bearing cup.
(4) Install the pinion front bearing cup (Fig. 31)
with Installer D–130 and Handle C–4171.
(5) Install pinion front bearing, and oil slinger, if
equipped.
(6) Apply a light coating of gear lubricant on the
lip of pinion seal. Install seal with Installer
C-4076–B and Handle C-4735-1 (Fig. 32).
Fig. 26 Front Bearing Cup Removal
1 – REMOVER
2 – HANDLE
Fig. 27 Rear Bearing Cup Removal
1 – DRIVER
2 – HANDLE
Fig. 28 Collapsible Spacer
1 – COLLAPSIBLE SPACER
2 – SHOULDER
3 – PINION
4 – PINION DEPTH SHIM
5 – REAR BEARING
Fig. 29 Rear Bearing Removal
1 – SPECIAL TOOL C-293–PA
2 – VISE
3 – ADAPTERS
4 – DRIVE PINION GEAR SHAFT
3 - 118 8 1/4 REAR AXLE XJ
REMOVAL AND INSTALLATION (Continued)
To Next Page