This measurement will give you the pinion
shaft or Input Yoke Angle (B).
(7) Subtract smaller figure from larger (C minus
B) to obtain axle Input Operating Angle.
Refer to rules given below and the example in
(Fig. 12) for additional information.
Fig. 11 Rear (Input) Angle Measurement (B)
1 – PINION YOKE BEARING CAP
2 – SPECIAL TOOL 7663 (J-23498A)
Fig. 12 Universal Joint Angle Example
1 – 4.9° Angle (C)
2 – 3.2° Angle (B)
3 – Input Yoke
4 – 3.0° Angle (A)
5 – Output Yoke
Fig. 10 Propeller Shaft Angle Measurement (C)
1 – SHAFT YOKE BEARING CAP
2 – SPECIAL TOOL 7663 (J23498–A)
XJ PROPELLER SHAFTS 3 - 7
SERVICE PROCEDURES (Continued)
To Next Page