Jeep Compass User Manual

102 GETTING TO KNOW YOUR INSTRUMENT PANEL
To reset the oil change indicator after
performing the scheduled maintenance, refer
to the following procedure:
1. Without pressing the brake pedal, push the
ENGINE START/STOP button and cycle the
ignition to the ON/RUN position (do not
start the engine).
2. Fully press the accelerator pedal, slowly,
three times within ten seconds.
3. Cycle the ignition to the OFF/LOCK position.
NOTE:
If the indicator message illuminates when you
start the vehicle, the oil change indicator
system did not reset. If necessary, repeat this
procedure.
DISPLAY AND MESSAGES — IF
E
QUIPPED
Includes the following, but not limited to:
 Front Seat Belts Unbuckled
 Driver Seat Belt Unbuckled
 Passenger Seat Belt Unbuckled
 Traction Control Off
 Washer Fluid Low
 Oil Pressure Low
 Oil Change Due
 Fuel Low
 Service Anti-lock Brake System
 Service Electronic Throttle Control
 Service Power Steering
 Cruise Off
 Cruise Ready
 ACC Override
 Cruise Set To XXX mph or km/h
 Tire Pressure Screen With Low Tire(s)
 Service Tire Pressure System
 Park Brake Engaged
 Brake Fluid Low
 Engine Temperature Hot
 Lights On
 Right Front Turn Signal Light Out
 Right Rear Turn Signal Light Out
 Left Front Turn Signal Light Out
 Left Rear Turn Signal Light Out
 Ignition or Accessory On
 Vehicle Not In Park
 Remote Start Active Push Start Button
 Remote Start Canceled Fuel Low
 Remote Start Canceled Door Open
 Remote Start Canceled Hood Open
21_M6_OM_EN_IN_t.book Page 102

Jeep Compass Specifications

General

Brand	Jeep
Model	Compass
Category	Automobile
Language	English