EasyManuals Logo

Jeep Compass User Manual

Jeep Compass
417 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #172 background imageLoading...
Page #172 background image
STARTING AND OPERATING 171
ACTIVATION
To activate the feature, push the Active Speed
Limiter button located on the right side of the
steering wheel. A message will appear along
with an indicator light in the instrument cluster
display to signal that Active Speed Limiter has
been activated.
After the Active Speed Limiter on/off button has
been pushed, you must press the SET (+) or SET
(–) button to set the target speed (or RES button
when there is already a previously set target).
Push the SET (+) or SET (–) button to raise and
lower the target speed to the desired value.
Pushing and holding down the SET (+) or SET (–)
button will increase/decrease the speed value
by increments of 5 mph (5 km/h).
Each time that Active Speed Limiter is
activated, it will be set to the last programmed
value from the previous activation.
NOTE:
The Cruise Control (if equipped) system will be
unavailable while the Active Speed Limiter is in
use.
EXCEEDING THE SET SPEED
By fully pressing the accelerator pedal, the
programmed maximum speed can be exceeded
while the device is active.
In the event that the Active Speed Limiter set
value is exceeded manually with a driver
acceleration, an audible indicator will sound.
The indicator light will rapidly flash, and a
message will appear in the instrument cluster
display.
The feature will remain disabled until the
vehicle speed drops below the set Active Speed
Limiter value, where it will reactivate
automatically.
DEACTIVATION
To turn off Active Speed Limiter, push the Active
Speed Limiter button on the right side of the
steering wheel. A message will appear in the
instrument cluster display to confirm that the
feature has been turned off. You can also
deactivate Active Speed Limiter by pressing the
CANC button. In this case, the system is not
completely turned off, and the driver can
reactivate the Active Speed Limiter by pressing
the RES button.
CRUISE CONTROL SYSTEMS — IF EQUIPPED
CRUISE CONTROL IF EQUIPPED
When engaged, the Cruise Control takes over
accelerator operations at speeds greater than
20 mph (32 km/h).
21_M6_OM_EN_IN_t.book Page 171

Table of Contents

Other manuals for Jeep Compass

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jeep Compass and is the answer not in the manual?

Jeep Compass Specifications

General IconGeneral
BrandJeep
ModelCompass
CategoryAutomobile
LanguageEnglish

Related product manuals