Jeep Compass User Manual

280 SAFETY
Suitability of Passenger Seats for i-Size
Child Restraint System Use
The rear outboard seats of the vehicle are
type-approved to house the state-of-the-art
i-Size child restraint systems.
These child restraint systems, built and
type-approved according to the i-Size (ECE
R129) standard, ensure better safety
conditions to carry children on board a vehicle:
 The child must be transported rearward
facing until 15 months:
 Child restraint system protection is increased
in the event of a side collision:
 The use of the ISOFIX system is promoted to
avoid faulty installation of the child restraint
system:
 Efficiency in the choice of the child restraint
system, which isn't made according to weight
anymore but according to the child's height,
is increased:
 Compatibility between the vehicle seats and
the child restraint systems is better: the i-Size
child restraint systems can be considered as
"Super ISOFIX"; this means that they can be
perfectly fitted in type-approved i-Size seats,
but can also be fitted in ISOFIX (ECE R44)
type-approved seats.
NOTE:
The vehicle seats, i-Size type-approved, are
marked by the symbol shown in Figure XX.
Figure XX
The following table, according to European
standard ECE 129, indicates the possibility of
i-Size child restraint system installation.
Key of letters used in the table above:
 i-U = Suitable for Universal i-Size child
restraint systems, both rearward facing and
forward facing.
 X = Seat not suitable for Universal i-Size child
restraint systems.
i-Size Child Seat Position Table
Device
Front
Passen-
ger
Rear
Out-
board
Rear
Center
i-Size
Child
Restraint
Systems
ISO/R2 X i-U X
ISO/F2 X i-U X
21_M6_OM_EN_IN_t.book Page 280

Jeep Compass Specifications

General

Brand	Jeep
Model	Compass
Category	Automobile
Language	English