32 GETTING TO KNOW YOUR VEHICLE
To Lock The Vehicle’s Doors And Liftgate
With one of the vehicle’s Passive Entry key fobs
within 5 ft (1.5 m) of either front door handle,
push the Passive Entry lock button located on
the outside door handle to lock the vehicle
doors and liftgate.
Push The Door Handle Button To Lock
NOTE:
DO NOT grab the door handle when pushing the
door handle lock button. This could unlock the
door(s).
DO NOT Grab The Door Handle When Locking
NOTE:
After pushing the door handle button, you
must wait two seconds before you can lock or
unlock the doors, using either Passive Entry
door handle. This is done to allow you to
check if the vehicle is locked by pulling the
door handle without the vehicle unlocking.
If Passive Entry is disabled using the
Uconnect Settings, the key protection
described in "Frequency Operated Button
Integrated Key (FOBIK-Safe)" remains active/
functional.
The Passive Entry system will not operate if
the key fob battery is depleted.
To Unlock/Enter The Liftgate
The liftgate Passive Entry unlock feature is built
into the electronic liftgate release handle. With
a valid Passive Entry key fob within 5 ft (1.5 m)
of the liftgate, push the electronic liftgate
release handle to open.
NOTE:
If the vehicle is unlocked, the liftgate will
open with the handle and no key fob is
required.
The liftgate will either unlock along with the
vehicle doors, or it will need to be unlocked
by pushing the electronic liftgate release,
depending on the selected setting in the
Uconnect system Ú page 200.
21_M6_OM_EN_IN_t.book Page 32
To Next Page
Loading...
