KNOWING YOUR CAR
36
Internal greeting lights
(where provided)
Located under the exterior mirrors, they
are small lights that illuminate the
ground when the doors are unlocked with
the key or are opened.
DAYTIME RUNNING LIGHTS
(DRL) AND SIDE LIGHTS
53) 54)
The LED daytime running lights are
switched on with the ignition device in
ENGINE position, parking brake engaged
and light switch (1) fig. 36 in position
. The other lights and interior lighting
remain off.
The LED daytime running lights and
side lights are switched on with the
ignition device in ENGINE position,
parking brake released and light switch
in position
. The other lights and
interior lighting remain off.
NOTE If allowed by law in the country
in which the car was purchased the
daytime running lights can be turned on
and off using the Uconnect™ system.
Refer to the “Settings” paragraph in the
“Multimedia” section.
DIPPED BEAMHEADLIGHTS
With the ignition device turned to
ENGINE, turn the switch (1) fig. 36 to
. The dipped beam headlights and
number plate lights switch on. The LED
daytime running lights stay on while
the side lights remain on at a lower
brightness.
The
warning light switches on in the
instrument panel.
MAIN BEAM HEADLIGHTS
To activate the fixed main beam
headlights, with the ignition device to
ENGINE, push left stalk (1) fig. 35
(direction of travel of the car). The light
switch should be turned to AUTO with the
dipped beam headlights on, or it should
be turned to position
.
To flash, the unstable position is used
(activate by pulling the lever towards
you). With main beam headlights on, the
warning light
on the instrument panel
will come on at the same time.
The main beam headlights are
deactivated bringing the lever back to
the central stable position. Warning light
switches off in the instrument panel.
Auto Dim HighBeams control
(where provided)
The system controls the automatic high
beam headlights providing increased
forward lighting at night by automating
high beam control using of a digital
camera mounted on the interior rear-view
mirror. In order not to dazzle other road
users, the lights are automatically
deactivated when approaching cars
travelling in the opposite direction or
when following a car travelling in the
same direction.
NOTES:
The Auto Dim High Beams control
can be turned on or off using the
Uconnect™ system. Refer to “Settings”
in the “Multimedia” section for further
information.
Broken, muddy or obstructed
headlights and side lights of vehicles in
the field of view of the camera will cause
headlights to remain on longer (closer
to the vehicle). Accumulations of dirt,
fouling or other obstructions on the
windscreen or camera lens also prevent
normal operation of the system.
To deactivate the automatic function
rotate the light switch ring to position
.
FLASHING THEHEADLIGHTS
To flash, the unstable position is used
(activate by pulling the lever towards
you). With main beam headlights on, the
warning light
on the instrument panel
will come on at the same time.
AUTO FUNCTION (Dusk sensor)
(where provided)
This system switches the headlights
on/off automatically according to the
environmental light.
IMPORTANT The function can only be
activated when the ignition device is in
the ENGINE position.
Function activation
Turn the light switch to AUTO.
To Next Page
Loading...
