EasyManua.ls Logo

Jeep Compass - Page 39

Jeep Compass
408 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
37
When the system is on, the “Headlight
time delay” feature is also on with
engine off. This means the headlights
will stay on for up to 90 seconds after
you put the ignition device in the STOP
position.
Function deactivation
To deactivate the function, turn the light
switch to a position other than AUTO.
HEADLIGHTS OFF TIMER
This safety function delays the switching
off of the headlights by up to 90
seconds. The delay can be programmed.
It is possible to enable switching on
the lights for the preset time by turning
the ignition device to STOP within 45
seconds with the light switch ring in
position and then turning the ring to
position
.
This function is deactivated by switching
on the headlights, the side lights or
bringing the ignition device to ENGINE.
NOTE:
If the light switch is in the AUTO
position prior to turning the ignition
device to STOP, there is no need to
turn the switch to
to activate the
headlight time delay.
The headlight time delay can be
programmed using the Uconnect™
system; refer to the “Settings” paragraph
in the “Multimedia section.
LIGHTS-ON REMINDER
(where provided)
If the headlights or side lights are on
after the ignition device is in the STOP
position, an acoustic warning will sound
to alert the driver when the driver's door
is opened.
FOG LIGHTS
(where provided)
The button which turns the fog lights on
and off is integrated in the light switch.
With the ignition device in ENGINE
position, with the side lights and dipped
beam headlights on, press switch
to
turn on the fog lights.
“Cornering Lights” function
(where provided)
The function activates with the high
beam headlights switched on with a
speed lower than 40 km/h. For wide
steering wheel rotation angles or at the
switching on the direction indicator, the
front fog light on the turning side will
light up to extend the night visibility
angle.
The Cornering Lights function can be
disabled using the Uconnect™ system
from the main menu by selecting in
sequence: "Settings", "Lights" and
"Cornering Lights".
REAR FOG LIGHT
The rear fog light switch is integrated
with the light switch.
With ignition device in the ENGINE
position, press button
to switch the
light on/off.
The rear fog light switches on only when
the dipped beam headlights or fog lights
are switched on. Press the button
again to switch the light off.
DIRECTION INDICATORS
Take the left stalk to the (stable)
position:
upwards: activates the right direction
indicator;
downwards: activates the left direction
indicator.
Warning light
or will blink on the
instrument panel.
NOTES:
If one of the indicators stay on without
flashing or if it flashes very fast, check
the integrity of the indicator bulbs.
Failure to turn on one of the indicators
when the control stalk is moved is most
likely due to the bulb itself being out of
operation.
The message "Direction indicators on"
will appear on the instrument panel
display and a continuous acoustic
warning will sound if you drive for longer
than 1.6 km with one of the direction
indicators on.
When a direction indicator is activated
with the daytime running lights on, the
daytime running light will switch off on
the concerned side and the direction
indicator will flash. The daytime running

Table of Contents

Other manuals for Jeep Compass

Related product manuals