Jensen AWM910 User Manual

7
AWM910
5. Auxiliary Input Function
Press AUX (5) to directly access auxiliary input mode from any other function mode when
portable audio device is connected to the unit. To connect a portable audio device, insert a
standard 3.5 mm (audio line output or headphone output from your portable CD / MP3 / iPod or
other media player) into an “AUX IN” jack on the front or rear of the unit.
Note: For front panel AUX input, and external audio source such as an audio (MP3) player
can be connected to the front panel AUX input with a separately purchased 3.5mm cable
adapter. Connect the device to the AUX input on the front panel and press AUX to engage
the input circuit.
6. Time/Frequency Display
Press T/F (6) momentarily to display the time while in Tuner, CD or auxiliary input mode.
7. Setting the Clock
Press T/F (6) to display the clock. Press and hold T/F, and the clock display will flash. While
holding T/F, press H (7a) to adjust the hour or M (7b) to adjust the minute. The new time will be
saved five seconds after the last adjustment is made.
8. Setting the Alarm
To set the alarm to a specific time, press and hold ALARM SET (8a), and the alarm time will flash
in the display. While holding ALARM SET, press H (7a) to adjust the hour or M (7b) to adjust the
minute. The new alarm time will be saved five seconds after the last adjustment is made.Once a
time is set, press ALARM ON/OFF (8b) to turn the alarm function on or off.
9. Speaker Output
The three speaker output buttons (9) (SPK A, SPK B and SPK A+B) control speaker output from
the radio. Press any of the three buttons to turn the corresponding speaker on or off. The red light
above each button will illuminate when that speaker is turned on.
10. Reset
Use a ballpoint pen or other thin metal object to press the reset button (10) under the following
circumstances: after the completion of initial installation/wiring, if none of the function buttons
work or if an error symbol appears in the display.

Jensen AWM910 Specifications

Power

power supply requirements	DC 12 Volts, Negative Ground
operating voltage	10-16VDC
total system power	50 Watts Maximum

FM Tuner

tuning range	87.5-107.9FM
sensitivity	<5uV
stereo separation at 1 kHz	>30dB

AM Tuner

tuning range	530-1710
sensitivity	<30uV

CD Player

frequency response	20Hz to 20kHz
signal to noise	65dB
compatible CD formats	Audio CD, CD-R, R/W

Amplifier

output power	25 Watts per Channel
output wiring	2/4 Speaker and Headphone System
output impedance	Compatible with 4-8 Ohm Speakers, 4 Ohm Load Minimum

Weight and Dimensions

overall dimensions	10-7/16"(W) x 7"(H) x 6-1/4"(D)
mounting dimensions	9-3/8"(W) x 6-1/8"(H) x 6-1/4"(D)
weight	3.5 lbs.(1.7 Kg)