3
®
CM715K
Connections
Good wire connections are very important for
best sound and long-term reliability. Here are
two methods:
Splice
1. Strip 1/2 inch (12 mm) of insulation from
both wires.
2. Wrap wires together.
3. Fold wires over.
4. Stretch electrical tape tightly over splice.
Professional Tip
Solder
Solder is the best way to connect wires, but it
takes skill and practice. Splice the wires (as
shown above). Before taping, heat the wires
(not the solder). When the wires are warm
enough, touch the solder to the splice. The
solder will flow over the wires. Stretch electrical
tape tightly over splice.
Upgrading Your System
Jensen makes a wide range of car stereo
products that will make your car system
sound better, great or INCREDIBLE!
Better Sound
Install a Jensen tape deck or CD player like
you’re doing now. High power units can make
your existing speakers sound better and play
louder.
Great Sound
Replace your existing speakers with Jensen
speakers. Many of our speakers will fit into
your car without cutting or drilling. You can
also add an amplified graphic equalizer to
tailor the sound to your liking.
INCREDIBLE Sound
Jensen offers a full line of amplifiers, high-
power speakers and subwoofers that can
turn your car into audio dynamite. You can go
loud, louder and loudest by selecting Jensen
components from your retailer.
Professional Tip
Professional Tip
Crimp Connections
Purchase crimp connectors and crimping
tool. Connectors are color coded. This
Jensen radio uses BLUE connectors (14-16
gauge wire).
1. Strip 1/4 inch (6mm) of insulation from
both wires.
2. Insert into connector.
3. Crimp tightly.
You can make permanent splices (using
butt connectors) or select connectors that
can be removed and reinstalled.
321
Strip wire
1/4" (6mm)
1
2
3
4
Rosin core
solder
Heat
wires
not
solder
Strip Wire
1/2" (12mm)
Soldering
iron
Solder
Splice
Untitled-3 4/10/99, 7:38 PM3
To Next Page
Loading...
Need help?
CD Player
