EasyManuals Logo

Jensen CM715K User Manual

Jensen CM715K
13 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #8 background imageLoading...
Page #8 background image
8
®
CM715K
Testing
Before you finish the installation, you should do the following tests to make sure the wiring is correct
and everything is operating properly.
Test Memory Wiring
Test Power Wiring
1. Turn ignition switch on. The display should
light. If not, check the electrical connection
at the yellow and red wires.
2. Press PWR button to turn the receiver on.
You will see the radio display. If not, check
electrical connections to the red and
yellow wires.
3. If equipped, the power antenna should
also operate. If not, check electrical
connections to the dark blue wire.
Reconnect Battery
When wiring is complete,
reconnect the battery
negative terminal.
1. With the radio playing,
hold button 1 for five
seconds. CH 1 will
appear in the display.
You just stored the
current station in
memory.
2. Turn the key off, then
turn the key on again.
3. Press
or . The
radio will select a
different station.
4. Press button 1 again.
It should return to the
station that was
playing before (step
1). If not, make sure
the yellow wire is
connected properly.
Test Antenna Connection
1. Press or . The radio should tune to a
nearby station. If not, check antenna
connection.
2. Press the
VOL
button
to increase volume
until you can hear the
radio playing.
Set the Clock
Press DISP button to temporarily display
clock.
To set the clock:
1. Press and hold DISP
button for more than
two seconds. Colon
will flash.
2. Within 3 seconds,
press
on the control
button to change the
minutes and
to
change the hours.
>2 sec
+
2
1
VOL
VOL
VOL
VOL
VOL
VOL
or
or
DISP
1
2
0
1
2
3
VOL
VOL
VOL
VOL
M
H
SCN RPT
MTL
AMS PGM
VOL
VOL
SCN
1
SCN
1
1
4
2
3
VOL
VOL
CH
5 sec
or
Untitled-3 4/10/99, 7:38 PM8

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Jensen CM715K and is the answer not in the manual?

Jensen CM715K Specifications

CD Player IconCD Player
signal-to-noise ratio>86 dB
frequency response20 Hz - 20 kHz
channel separation>65 dB
Tape Player IconTape Player
frequency response±3 dB, 50 Hz-15 kHz
wow and flutter0.13% JIS
signal-to-noise ratio (a-weighted)65 dB
FM Tuner IconFM Tuner
tuning range87.5 MHz-107.9 MHz
FM mono sensitivity12 dBf
50 dB quieting sensitivity (stereo)16 dBf
AM Tuner IconAM Tuner
tuning range530 kHz-1720 kHz
Amplifier IconAmplifier
total system power160 watts peak
power output (front)2 x 40W
power output (rear)2 x 40W
General IconGeneral
power supply11-16 VDC, negative ground
speaker output impedance4-8 Ohms
fusesfast blow AGC (2 amp and 10 amp)

Related product manuals