23
MP1516
Balance
1. Press the SEL button repeatedly until "BAL" appears on the display panel.
2. Rotate the volume knob to adjust the balance between the left and right
speakers.
Fader
1. Press the SEL button repeatedly until "FAD" appears on the display panel.
2. Rotate the volume knob to adjust the balance between the front and rear
speakers.
Setting the Clock
The time clock can be set anytime when the power is on.
1. Press the CLK/PTY button on the faceplate or the Clock button on the remote
control once (press and hold for more than 2 seconds during radio mode). The
time will appear on the display panel.
2. Press and hold the button until the hour blinks on the display panel. Rotate
the volume knob to set the hours.
3. Press the volume knob for the minutes to blink. Rotate the volume knob to set
the minutes.
4. Press the CLK/PTY button on the faceplate or the Clock button on the remote
control again or leave the unit idle for new setting to take eect.
5. Press the CLK/PTY button on the faceplate or the Clock button on the remote
control anytime to view the time clock display.
Turning the Preset Beep Sound On or O
1. Press the SEL button repeatedly until “BEEP ON” appears on the display panel.
2. Rotate the volume knob to select "BEEP OFF" or "BEEP ON",
3. Leave the unit idle for the setting to take eect.
Preset Equalizer Function
The Equalizer Preset function applies a preset sound level to the unit’s audio
output signal in accordance to the type of music being played.
To Select an Equalizer Preset:
1. Press the SEL button repeatedly until “EQ” appears in the display panel.
2. Rotate the volume knob to choose the equalizer sound eects. The sequence
of equalizer settings will be as follows:
JAZZ
To Next Page
Loading...
Need help?
General
