To Next Page

To Previous Page

MP1516

MP3/WMA Playback

To play MP3/WMA les from a SD card, remove the faceplate and insert a SD card

into the SD Memory Card Slot on the housing. The unit will start playing MP3/

WMA les on the SD card memory automatically when the faceplate is installed.

If the MP3/WMA les are stored in folders on the SD card, the unit will start by

playing the rst song in the rst folder. After playing all the les sequentially in the

rst folder, the unit will play sequentially all of the les in the next folder. The unit

will continue playing through all of the folders on the SD card in this manner.

If the SD card has loose les and folders containing les, it will play the loose les

sequentially, then it will play the les in the folders sequentially.

iPod®/iPhone® OPERATION

Connect your iPod

Connect your iPod or iPhone with the original iPod cable (supplied with the iPod).

This unit can play all audio from an iPod or iPhone up to the iPhone 4S and iPod

Touch 4G. The iPad is not supported.

Play/Pause

Once the unit has been connected, playback will start automatically. During

playback, press the “ ” to play, pause or resume play.

Browsing your iPod

1. Press the F/PS button. “PLAY LIST” will appear on the display panel.

2. Rotate the volume knob to cycle through “PLAY LIST”, “ARTIST”, “ALBUM”,

“GENRE”, “SONGS”, “COMPOSER”, “AUDIO BOOK”, and “PODCAST”. The listing is

the same as your iPod’s listing.

3. Press the volume knob to conrm your desired category.

4. Rotate the volume knob for further selection and press the volume knob to

conrm.

Detaching your iPod

Unplug your iPod cable from the USB port anytime to eject the iPod.

Jensen MP1516 User Manual

Questions and Answers: