What to do if the overheating LED illuminates on my JESS WELDING SynMag 2600?
If the overheating LED illuminates, it could be due to exceeding the duty cycle or insufficient ventilation. Allow the machine to cool down, and ensure it has good cooling.
Why won't my JESS WELDING SynMag 2600 start welding when I press the torch trigger?
If the welding process cannot be started, it could be due to a few reasons: * The central connector on the welding torch may not be tightened. Ensure you insert and lock the connector. * The control lead could be defective, in which case you should replace it. * The electrical control system might be defective; consider replacing it.
What to do if there is no welding current but the wire feeder motor is running on my JESS WELDING SynMag 2600?
If there is no welding current but the wire feeder motor is running, the earth cable might be interrupted. Replace the earth cable to resolve this issue.
How to fix the indicator light if it doesn't illuminate when the main switch is on for my JESS WELDING SynMag 2600?
If the indicator light does not illuminate when the main switch is on, it could be due to: * An interrupted power supply line. Check the supply line. * Defective mains fuses. Replace the fuses. * A defective main switch. Replace the main switch.
What does it mean if the cooling circuit LED illuminates and error 1 appears on my JESS WELDING Portable Generator (SynMag 3600/4100/5100)?
If the cooling circuit LED illuminates and error 1 appears, the flow control has likely activated. Top up the cooling water. Also, ensure the welding torch’s hoses are connected.
General| Brand | JESS WELDING |
|---|---|
| Model | SynMag 2600 |
| Category | Portable Generator |
| Language | English |
To Next Page