B
brianclarkAug 17, 2025
Why does the chuck or arbor not stay in place on my Jet JDP-17DX?
- LLori TurnerAug 17, 2025
If the chuck or arbor doesn't stay in place on your Jet Power Tool, clean all mating surfaces thoroughly with a cleaner degreaser.
To Next PageTo Next PageTo Previous PageTo Previous Page
Loading...Why does the chuck or arbor not stay in place on my Jet JDP-17DX?
If the chuck or arbor doesn't stay in place on your Jet Power Tool, clean all mating surfaces thoroughly with a cleaner degreaser.
How to troubleshoot a Jet Power Tool drill press that won't start?
If your Jet Power Tool drill press won't start, here's what to check: * Ensure the drill press is properly plugged into the wall and the motor. * Inspect the fuse and replace it if blown, or reset the circuit breaker. * Examine the cord for any damage and replace it if necessary. * The starting capacitor might be faulty and require replacement.
Why is my Jet Power Tool making so much noise?
If your Jet Power Tool is operating noisily: * Check and adjust the belt tension. * Lubricate the spindle. * Inspect the retaining nut on the spindle pulley for tightness and tighten if needed. * Tighten the set screws in the pulleys.
General| Number of Speeds | 5 |
|---|---|
| Motor Power | 3/4 HP |
| Swing | 17 inches |
| Drilling Capacity in Steel | 16 mm |
| Voltage | 115/230V |
Accessing additional product details and updates.
Details on JET product warranties, coverage, and service procedures.
Critical safety instructions for operating the drill press safely.
Requirements for safety glasses, ear protection, and appropriate clothing.
Guidelines for maintaining a safe workspace and handling hazardous materials.
Instructions for using a padlock to prevent unauthorized operation.
Introduction to the manual's content and purpose.
Technical details and measurements of the drill press.
List of all parts included in the product packaging.
Initial steps and preparation before assembling the drill press.
Instructions for assembling the base and column components.
Steps for attaching the table and rack mechanisms.
Installation of table crank and column lock handles.
How to install the downfeed handles.
Procedures for properly installing the chuck and arbor.
Essential steps for safely grounding the drill press.
Information on operating the drill press at 115 volts.
Guidelines for selecting and using appropriate extension cords.
Steps for detaching the chuck and arbor.
How to set the depth stop for drilling.
Procedure for adjusting spindle speeds via belt changes.
How to adjust the return spring tension.
Steps to adjust the tilt angle of the drill press table.
How to align the laser vertically.
Procedure for aligning laser crosshairs.
Steps for removing and reinstalling the laser assembly.
Instructions for installing the drill press lamp bulb.
Identification and function of the drill press controls.
Guidelines for safe and effective drill press operation.
Recommended lubrication points and frequency.
Solutions for common drill press problems and malfunctions.
How to order necessary replacement parts.
Introduction to the detailed parts list.
Visual representation of all drill press components.
Diagram showing the electrical connections and components.
Space for user to record important notes and observations.
